Home / Dining Sets & Chairs / Industrial Dining Chairs Set of 6, Black
Industrial Dining Chairs Set of 6, Black
Dining Sets & Chairs

Industrial Dining Chairs Set of 6, Black

Part of the Dining Sets & Chairs collection
$169.99
Buy Now

Buying six chairs at once solves a problem four never quite does — the moment two more people arrive. These are the industrial pattern: a padded PU seat over an MDF base, a wooden backrest set at 99 degrees so the spine sits back rather than upright, and a multi-tube metal frame that carries 250 lb without flexing. Each chair is 16.2 by 18.5 inches and 34 tall, which is narrow enough that six fit round a normal table.

Quantity
Set of 6
Seat
4 cm PU leather cushion
Back
MDF, 99° tilt
Each chair
16.2 x 18.5 x 34 in, 250 lb

How it lives in the room

Count the edge, not the seats

Six chairs want about 24 inches of table edge each. On a round 51-inch top that works; on a 42 it does not, whatever the listing says.

Build all six together

Same four fixings each. Assemble in a line rather than one at a time and the whole set takes half an hour instead of an evening.

Then check the feet

Metal legs on a hard floor need pads. Fit them before the first meal, not after the first scratch.

Before you order

Do not fully tighten any bolt until every part of a chair is loosely in place. Chair frames rack if the first joint is locked down early, and a racked frame is the usual cause of a wobble that no amount of later tightening will fix.